ARC CinemaII OM 7/17/98 4:32 PM Page 14
Test ToneCenter-Channel VolumeRear-Channel Volume
For proper Dolby Pro LogicUsing the remote control, pushvolume level of the surroundHall3-StereoPro LogicHall3-StereoPro Logic
operation, a test tone is usedOTest Tone.� Then adjust thechannels is generally muchCENTERTESTDelay Cent ModeBypassDelay Cent ModeBypass
to calibrate the volume set-HALLMODETONE BYPASSCenter and Surround levelslower than that of the front
tings of the speakers. A noiseuntil the volume of all thechannels. In fact, when Test Tone Center Level VolumeTest Tone Center Level Volume
will be heard cycling, in order,speakers is the same duringlistening to a movie, virtually
Rear LevelRear Level
from the front left, center,the test.all of the dialogue and a sub-
right and both surround Note:The test tone is used tostantial number of the effects
SurroundSurround
speakers.calibrate the performance ofare reproduced through the
the system. When listening center channel.
Push OCenter Level� or Push ORear Level� or
to an actual recording, the
until the volume of the centeruntil the volume of the rear
speaker is the same as that ofspeaker is the same as that of
the left and right speakers.the left and right speakers.
Center Mode
Hall3-StereoPro LogicNormal: Select this mode Phantom: Select this mode
CENTERTESTif you use a small centerif you donOt use a center
HALLMODETONE BYPASSDelay Cent ModeBypassspeaker. The bass sound of thespeaker. The center speakerOs
Test Tone Center Level Volumecenter channel is reproducedsound is reproduced from the
from the front left and rightfront left and right speakers.
Rear Level
speakers because the small
Power TuningAuto
speaker cannot produce
Surround
enough bass.
Wide: Select this mode if you123
Press OCenter Mode� on theor the remote to switchTuner
use a medium-to-large center
receiver between ONormal,� OWide� and4657
speaker. The bass sound isMemory
OPhantom.�
reproduced from the center809
P.Scan FM/AM
speaker.
CDTAPEAUX/TVTuner
VCR1VCR2SleepMute
40
Hall3-StereoPro Logic
35
Delay Time
Delay Cent ModeBypass
30
The delay control allows theHall3-StereoPro LogicHall3-StereoPro Logic
Test Tone Center Level Volume
user to set the surround delay
2515ms
Delay Cent ModeBypassDelay Cent ModeBypass
between 15 and 30 milli-Rear Level
15ms
seconds. The best setting will20Test Tone Center Level VolumeTest Tone Center Level Volume15ms
Surround
depend on the distance20ms
1520ms
between the main listeningRear LevelRear Level
30ms
area and the front speakers, as10
30ms
SurroundSurround
well as the distance between
30ms
the main listening area and 5
Distance (in feet) From Rear Speakers
the rear speakers. Push ODelay� on the remotePush ODelay� on the remote
0
The chart on the right showsuntil ODelay� appears in theto cycle through the delay
0 5 10 15 20 25 30 35 40
the recommended settings.display and the correspondingtimes.
Distance (in feet) From Front Speakers
time is lit.
Preferable Acceptable
� 14 � |
ACEC
